headlines

Select Your local Language

Thursday, February 28, 2019

kitchen sink drainage block problems 5 tips.



Kitchen sink drain is a very common plumbing problem. The build-up that naturally collects over time reduces the size of the drain, effectively slowing the progress of draining water. This drainage issue happens naturally over time and usually cannot be avoided. The only solution is to clean the drain periodically to keep it flowing.



1. Boiling water

This is the easiest and least expensive solution of all, which makes it the best one to try first. Place a kettle or pot of water on the stove and bring to a rolling boil. While you’re waiting for the water to heat, remove as much standing water from the sink as you can, using a mug or small pot to bail out the water. Then, pour the entire kettle of water into the sink and wait. If the water stands in the sink and the clog doesn’t move, give the water time to cool and remove it to try again. You may need to repeat the process several times to move the clog, but this often works on many types of stoppage.

2. Vinegar and baking soda
 Again, remove standing water first. Pour about a cup or so of baking soda into the drain, followed by an equal amount of white or apple cider vinegar. The solution will bubble, but when they subside, put the stopper in and wait about 15 minutes. Next, run hot water to see if the clog clears. Repeat if needed.

3. Disposal
Check to make sure it’s not your garbage disposal that's causing the problem. A clogged disposal can stop up the drain, so run the disposal to see if that clears the clog. Then inspect it to make sure it’s running correctly. If the disposal has overheated, you may need to flip the switch found on the side or bottom of the unit underneath the sink.

4. Baking soda and salt
This is another combination that can work on sink clogs. Mix about a cup of baking soda with a half-cup of salt, and pour down the drain. Let the mixture sit for several hours, then flush with boiling water. You can repeat this process if it doesn’t work the first time.

5. Salt and boiling water
After removing standing water from the sink, pour about ½ cup of table salt down the drain before you pour in the boiling water. Let it sit for a few minutes, and then flush with hot water to clear the mixture.

No comments:

Post a Comment